A sediment source adds extra sediment into the system and will be included in the sediment balance for the specified location. The source may have a negative value and behave like a sink; extracting sediment from the system.
You specify a source by clicking on the ‘New source’ button in the List View. By selecting a source in the Source list and clicking on the ‘Delete source’ button you can remove this source. For each source, you can specify the name of the source and whether the source should be active or not. The specification of detailed information for each source is made subsequently. From the list view page you can go to the dialogue for specification by clicking on the ‘Go to...’ button.
The Geographic view display the location of the sources.
Note: Sources cannot be located at a boundary point.
