GeoViewer Output

The GeoViewer is a MIKE Zero tool that is used in the MIKE GeoModel prod­uct for viewing geologic cross-sections in your conceptual model.

The GeoViewer Output extra parameters will create a set of dfs2 output files during the pre-processing that will allow you to look at your pre-processed model in the GeoViewer.

The GeoViewer Output is activated by

Parameter Name

Type

Value

make SZ level dfs2 files

Boolean

On

Optional

adjust dfs2 levels

Boolean

On

If this option is active, then the following files will be created:

·         setupname\setupname_GeoLayers.dfs2 - containing the top and bottom of each geologic layer

If there are lenses:

·         setupname\setupname_GeoLenses.dfs2 - containing the top and bottom of each geologic lense and delete values where there are no lenses

If the computational layers are not defined by geologic layers:

·         setupname\setupname_CompLayers.dfs2 - containing the top and bot­tom of each computational layer

If the optional second parameter is used, then the top and bottom elevations that are written to the files will be adjusted to be confined between the topog­raphy and the lowest computational layer.