Initial component concentrations are defined on this property page. If an initial concentration is not specified a default value of zero will be applied throughout the model. Global and local values of initial concentrations can be specified for each component. Local values are specified by entering the river branch name, chainage and concentration in the local values table. Initial concentrations are not used if the AD simulation is started with a hotstart file.
Component
Here the component in question is selected. It is possible to choose between the components defined in the Advection-Dispersion parameters Components property page by selecting from the drop-down selection box present in the ‘Component’ column.
Initial value
The initial value for the specific component is defined here. The initial value units are those defined in the Advection-Dispersion parameters Components property page for the advection-dispersion component.
MIKE HYDRO will use the initial values specified under global values except for those locations were local values have been specified. To add or remove locations with local initial values use the Append and Delete buttons.
Branch name
The name of the river branch with the local initial value.
Component
Here the component with a local initial value is selected. It is possible to choose between the components defined in the Advection-Dispersion parameters Components property page by selecting from the drop-down selection box present in the ‘Component’ column.
Chainage
The chainage in the river branch with the local value.
Initial value
The local initial value for the specific component is defined here. The initial value units are those defined in the Advection-Dispersion parameters Components property page for the Advection-Dispersion component.