The output from a river simulation is automatically loaded to the result view. However if results from a previous simulation should be loaded for comparison the corresponding res1d file should be loaded.
At the top of the Property view the available data types are shown in a combobox. When choosing a data type the available branches are shown below. When choosing a branch the available grid points are displayed below.
Right-clicking in the Property view shows a menu for either adding the result to a new plot or the current plot. Double-clicking on a point will automatically add the result to the current plot.
Selecting a point in the Property view highlights both the point and the related branch on the map.
Note: To find the selected branch the button ‘Zoom to selected branch’ can be used.
Selecting a branch or point in the Map view automatically selects the related time series in the Property view. Right-clicking on a point gives access to the menu ‘Result to plot’ where results can be plotted either on a new plot or the current plot.
Note: It is only possible to select results in the Map view, if the Map ribbon is active and set to ‘Pan’.
