Run
The Run menu contains options for calculation, validation and simulation of model components.
The Q/h relations of structures (weirs and culverts) must be recalculated if any changes are made to the structures and/or the up/down-stream cross sections.
Only structures where the flag ‘Allow for recalculation’ has been enabled will be recalculated.
Before running the model, it is recommended to run an extended validation of the model setup. Any validation issues will be shown in the Validation window see section Validation (p. 26).
To execute the model engine, select ‘Simulation’. Output from the computational engine (status and error messages) are shown in the Simulation window see section Simulation (p. 26).