2.2           Filtering charts

Each chart has several filtering options and buttons above it. These are:

-       Location Name: a dropdown with all locations within the area. The points are marked by the type of data: FC stands for Forecast data, MPB stands for Measured data (from a PuBlic source) and MPR stands for Measured data (from a PRivate source a.k.a. data provided by your organisation specifically).
So Fino 1 (FC) contains forecasting data based on models, Fino 1 (MPB) contains data from a public source measured at the Fino 1 location and Fino 1 (MPR) would i.e. be data from a buoy of your own organisation at the Fino 1 location.

-       Data Type: a dropdown with all data types (can be: Waves (Total), Waves (Wind-Sea), Waves (Swell), Water level, Surface current, Wind speed, Pressure).

-       Hm0 threshold: a number can be entered which will act as a threshold value for Hm0: values below the threshold will be marked in red in the table.

-       Hindcast length: same as the one at the top but acting as a filter for this table only.

-       Forecast length: same as the one at the top but acting as a filter for this table only.

-        help section (currently not specific per table)

-        table view, click to jump to table view of the selected table instead. Will then be replaced with , which can switch the view back to the chart that was shown before.

-        minimize the chart, will then be replaced with  which can expand the chart again.

-        remove the chart from the overviews. A pop-up will request confirmation before the chart is removed:

You will need to click Confirm to delete a chart.

Underneath all these is a legend that also acts as a filter:

The items vary per data type, but when clicked they will turn off or on in the chart.