The example demonstrates calibration of the AD module included in MIKE11. The calibration is made by parameter optimisation on the dispersion coefficient for each branch and the decay coefficient for the component studied.
The setup used in the example is a river network including a Branch1 connected to a Branch2 approximately midway (reused from example1). The two upper bounds are discharge bounds and the downstream boundary is a water level boundary.
The example is included as Example3\Test3-Autocal.auc. The HD model is the model calibrated in example 1.
The objective of the example is to calibrate the model with respect to the AD parameters, given timeseries of concentration measured at three different locations in the river.
Parameter optimisation, AD Parameters
Simulation specifications
Model Parameters
Objective Functions
Parameter Optimisation
Results