Setup Data Tab

·         This chapter is organized around the Setup Data Tree. For each branch in the data tree there is a corresponding subsection. The main sections include:

·         Display (V1 p. 176) - display of map overlays

·         Simulation Specification (V1 p. 182) - control and selection of water movement engines

·         Water Quality Simulation Specification (V1 p. 202) - control and selec­tion of water quality engines

·         Species (V1 p. 219) - specification of species for water quality simula­tions

·         Water Quality Sorption and Decay (V1 p. 221)

·         Model Domain and Grid (V1 p. 224) - definition of model extent and grid

·         Subcatchments (V1 p. 226) - definition of catchment boundaries for lumped parameter water movement engines

·         Topography (V1 p. 228) - specification of land surface elevation

·         Climate (V1 p. 229) - specification and extent of climate measurements, such as precipitation and evapotranspiration

·         Land Use (V1 p. 244) - specification of vegetation and irrigation

·         Rivers and Lakes (V1 p. 262) - link to MIKE Hydro River channel flow model

·         Overland Flow (V1 p. 265) - specification of 2D overland sheet flow parameters for both water movement and water quality

·         Unsaturated Zone (V1 p. 282) - specification of 1D unsaturated zone columns

·         Groundwater table for lower UZ boundary (V1 p. 298) - specification of static lower boundary condition for unsaturated flow, if saturated zone not included

·         Saturated Zone (V1 p. 298) - specification of 3D saturated zone param­eters for both water movement and water quality

·         Sources (V1 p. 333) - location and extent of solute sources for water quality simulation

·         Storing of Results (V1 p. 335) - output selection for calibration time series and gridded data

·         Extra Parameters (V1 p. 347) - extra input data for model options not yet available in the data tree